Casio QW-5311 - Installing Hands

QW-5311
– 15 –15 ––
6-6. INSTALLING HANDS
6-6-1. Procedures
Note:
• “HANDPOSITIONDETECTIONFORINSTAL-
LATION” is available. Before press tting the
hands,Performtheaboveoperationwrittenin
P.17.
• After installing the hands, be sure to perform
P.8.“ADJUSTING THE BASELINE POSI-
TIONOFHANDS”inordertocheckandadjust
theaccuracyofthebaselineposition.
Procedures Buttonoperations,additionalinstructions
 1. Preparation
1)Insertabattery
 2. Short-circuittheMPterminal
MPterminal
VSSterminal
staple
tape
  Short-circuittheMPandVSSterminalsusingametalobjectlikeastaple.Keepbothterminals
short-circuited.
 3. Perform“HANDPOSITIONDETECTIONFORINSTALLATION”
Ifthehandneedstobere-installedafterthisstep,besuretoperform“HANDPOSITIONDE-
TECTIONFORINSTALLATION”.
 4. Presstthemodehand
 Presstthemodehandtothe12:00
position.
 • accuracy:Within±0.5°
 5. Presstthe24-hourhand
 Presstthe24-hourhandto
the12:00position.
 • accuracy:Within±0.5°
Crown
Second hand
Hour hand
Mode hand
Minute hand
24-hour hand
Location of the buttons and names of the hands