Casio SI-460

26 27
FLASH: 600MS
BACK CHANGE NEXT
02
BACK EDIT NEXT
02 G
SAVE < NEXT
02 <NAME>
SAVE < NEXT
02 3105551212
DEL < NEXT
SAVE TO LOC 01
YES NO
SANDY LEE
123-456-7800
PROGRAMMING
PROGRAMMING
PROGRAMMING AUTODIAL
ENTERING AUTODIAL RECORDS
To manually enter a name and number into autodial,
PLEASE SELECT
PHON ANSW OTHER
PROGRAMMING AUTODIAL
Each SI-460 in the system can store up to 20 autodial numbers. Ten 16-digit numbers can be
accessed with the autodial key and ten additional entries using the lower register key followed by
the autodial key. Each autodial entry can have up to 16 digits and can have 14 characters for the
name. Once a number has been stored in an autodial location, press the selected autodial
location key to have the SI-460 automatically dial the programmed number.
AUTODIAL CARD
PROGRAMMING A CALLER ID RECORD
INTO AUTODIAL
To enter a caller ID record from your directory into an autodial location:
1.Press
CALLER ID
.
2.Press the < or > soft keys to scroll through
records.
3.When the caller ID record you want to
store into autodial appears in the display,
press and hold the selected autodial key
location.
4.After you hear a beep:
5.The telephone number of the caller ID
record will appear in the display. Press
“NEXT” to accept the number. (To edit the
number, see page 28 “EDITING AUTODIAL
ENTRIES.”)
NOTE:
■ Include the outside line digit if one is needed to dial.
6.The caller ID name will now appear in the
display. Press the soft key under “SAVE”
to store the name and number. (To edit the
name, see page 28 “EDITING AUTODIAL
ENTRIES.”)
7.Press
CALLER ID
to exit.
01
BACK EDIT NEXT
Autodial numbers can be programmed in two ways:
LOWER
Home
Bank
Joe Client
Agency
Direct Line
Car
Sue Smith
Remove the autodial card. Write down the names and/or telephone
numbers associated with the stored speed dial numbers and replace
the autodial card and plastic cover. An extra autodial card is
provided for your convenience.
AUTODIAL SETUP
BACK ENTER NEXT
02 GRANDMA
SAVE < NEXT
9.
Use the keypad to enter the name, up to
14 characters. Pressing a key once will
display the first letter on that key. Pressing
it repeatedly will cycle through all the
characters on the key.
NOTE:
■ Pressing the 1 key will add a space.
10.When the desired letter appears in the
display, press the soft key under “NEXT”
to move the cursor to the right.
11.Repeat steps 8 and 9 until the name is
entered.
12.
13.
Repeat steps 4 through 11 to program
the remaining autodial numbers.
14.Press
PROGRAM
to exit.
1.Press
PROGRAM
.
2.
3.
4.
5.
Press the soft key under “NEXT” to select
an autodial location (01-20).
6.
7.
If a number has not already been
programmed, “<NUMBER>” will appear in
the display. Use the keypad to enter the
autodial number, up to 16 digits. If the
number is entered incorrectly, press the
soft key under “
<” to move the cursor left
and the soft key under “DEL” to remove
digits. Use the keypad to
re-enter the correct digits.
NOTE:
■ Include the outside line digit if one is needed to dial
out of the system.
8.