69
To switch the Data Projector connection profile
1
On the Data Projector’s remote controller, press the [] key.
z This will cause the connection profile menu to appear in the projection area.
2
Use the [T] and [S] keys to move the highlighting to the connection profile you
want to select and then press the [ENTER] key.
z This displays the dialog box shown below.
3
Press the [S] key to move the highlighting to “Yes” and then press the [ENTER]
key.
z This will switch to the Data Projector connection profile you highlighted in step 2 and
then display the “Standing by for connection...” message.
The currently selected connection
profiled is highlighted.
This is the display of the connection
profile name after switching.
To Next Page
Loading...
