70
To use Web Setup to modify the Data Projector connection profile from a
computer
Important!
Performing the procedure below will terminate the current wireless LAN connection
between the Data Projector and computer. To re-establish a connection, reconfigure the
computer’s wireless LAN settings so they match those of the new Data Projector
connection profile.
1
Perform the procedure under “To display and log into the Web Setup page”
(page 65) to display the Web Setup top page.
2
Click the “Connection Profile” down arrow button and then select the connection
profile you want from the menu that appears.
3
Click the [Switch] button.
z This will display the following message on the Web Setup page.
4
Click the [OK] button.
z This will switch the Data Projector to the connection profile you selected in step 2 and
terminate the current wireless LAN connection between Data Projector and computer.
z At this time, the message “Standing by for connection...” will appear in the projection
area, along with the connection profile you switched with “Connection Profile” in step 2
above.
The connection profile has been changed.
Switch the settings on the computer and then re-connect.
To Next Page
Loading...
