21
8.
Enter the passphrase.
z The passphrase entered in the “Passphrase/WEP Key Input” text box depends on the security
protocol you selected in step 7, as described below.
z Each passphrase key character you input is indicated by an asterisk (*) in the applicable input
box. If you want to see the actual characters you input, clear the “Hide characters” check box.
z The passphrase you input will be required when you use the user SSID to establish a wireless
LAN connection between the projector and a computer. Make sure you do not forget the
passphrase you input.
9.
To create a user SSID in accordance with your settings in steps 6 through 8, click
[Apply].
z This creates the user SSID and applies it to the projector.
z If the projector and computer are connected via wireless LAN, this terminates the wireless
LAN connection between the projector and computer, and changes the projection screen to
the LAN connection standby screen.
Security Input Character String
WPA-PSK AES
Enter the WPA-PSK or WPA2-PSK passphrase. Enter at least eight and up to 63
single-byte characters, or a hexadecimal value up to 64 digits long.
Example:
MyKey123 (Eight single-byte characters)
1111222233334444555566667777888899990000AAAABBBBCCCCDDDDEEEEFFFF
(64-digit hexadecimal value)
WPA2-PSK AES
Disable No input required.
To Next Page
Loading...
