Casio XJ-UT310WN - To Change the Projectors IP Address Based on the Computers IP Address and Connect by Wired LAN

56
To change the projector’s IP address based on the computer’s
IP address and connect by wired LAN
Note
z Use the procedure below when you know the computer’s IP address.
1. Use a LAN cable to connect a computer directly to the projector.
2. Specify the projector’s IP address manually.
(1) Perform the following steps to display the IP Settings dialog box: [MENU] key 3
“Network Settings” 3 “Projector Wired LAN Settings”.
z The initial default setting for “IP Settings” is “Auto”.
(2) Press the [X] key to select “Manual” for “IP Settings”.
(3) Use the [T] key to select “IP Address” and then press the [ENTER] key.
z This will display the Input IP Address dialog box.
(4) Use the [W] and [X] keys to change Octet 1 of the IP address so it is the same as the
computer’s IP address After the setting is the way you want press the [T] key.
(5) Repeat step (4) to specify Octets 2 through 4.
z Octets 2 and 3 should be the same as those of the computer’s IP address.
z Octet 4 should be a value in the range of 1 to 254, and different from Octet 4 of the
computer’s IP address.
(6) Press the [ESC] key to return to “Network Settings”.
(7) Select “Update Network Settings” and then press the [ENTER] key.
(8) In response to the network setting update dialog box that appears, press the [S] key to
select “Yes” and then press the [ENTER] key.
3. Perform the operation starting from step 2 under “To log in to the Projector
Admin pages over a wired LAN connection” (page 54).