stainless steel pan-
els from all internal
and external sur-
faces (fig. 2).
• Always wear
protective gloves
when handling
packing material
and the wood
base.
• NB Dispose of packing materials in com-
pliance with disposal regulations applied
in the country where the machine is to be
installed. Never dispose of materials in
the environment.
1.5 General safety regulations
Failure to observe the recommendations
made by the present manual will be at the
entire responsibility of the machine user.
The main safety regulations are as follows:
- do not touch the machine with moist
or wet hands or feet;
- never operate the machine while bare-
foot;
- do not insert screwdrivers, cooking
utensils or any other object between
the guards and moving parts;
- before performing cleaning or routine
maintenance operations, disconnect
the machine from the power supply at
the master switch and the main knife
switch (if present);
- never pull on the power cable to dis-
connect the machine from the power
supply.
6
2.1 Data plate information
• Check that the data specified on the
plate correspond to the characteristics
of the power supply (V, kW, Hz, no. phas-
es and power available).
• The dataplate with appliance specifica-
tions is located at the rear exterior of the
machine and/or
on the electrical
boards (fig. 3).
The set-up
of individual
units and the
installation of condensers are subject to
the fire-safety regulations of the country
in which the machine is installed; seek all
necessary advice from the local fire-
fighting authorities.
Bear in mind that the intervention of safe-
ty valves or plug fuses in the refrigerat-
ing circuit will lead to the immediate dis-
charge of refrigerant into the environ-
ment.
2.2 Positioning
• The machine must be installed and com-
missioned in complete compliance with
safety regulations, procedures and
standing laws.
• The installation technician bears the
responsibility of ensuring compliance
with fire safety requirements; seek all
necessary advice from the local fire-
fighting authorities.
• Position the machine in the allocated
site.
• Adjust the machine feet until the appli-
ance is perfectly level. In the case of
particularly heavy equipment, use
appropriate lifting means
WW
WW
AA
AA
RR
RR
NN
NN
II
II
NN
NN
GG
GG
!!
!!
!!
!!
!!
!!
THESE OPERATIONS MUST BE
PERFORMED BY A CERTIFIED INSTALLATION
TECHNICIAN ONLY.
2. INSTALLATION
To Next Page
Loading...