13
5.2 SOFT BLAST CHILLING BY TEMPERATURE (pre-cooked, hot foods)
• To select this cycle, press push-button 2 (relative LED lights up), then press push-but-
ton 5 to select the temperature mode (LED 5A on)
• Insert the core probe into the core of the product to be chilled.
• Start up the cycle by pressing push-button 6 . LED 5A and those relative to the
push-buttons pressed illuminate throughout the cycle, while LEDs 13 flash.
• Display 15 indicates the maximum blast chilling time (starting temperature to end of
the blast chilling temperature - factory setting - 90 minutes).
• The temperature measured by the core probe is shown by display 16 .
• The instrument timer starts the countdown of the maximum blast chilling time as soon as the
temperature measured by the core probe falls below the temperature of +65°C (the dot at
the bottom right of display 15 flashes).
• During the blast chilling cycle, the air temperature is around 0°C.
This function is designed to guarantee uniform cooling of the product, preventing frost for-
mation on the surfaces. During the blast chilling cycle, the compressor may therefore stop
and restart, depending on the reading of the cell temperature probe.
• The blast chilling phase ends only when the core probe (inserted in the product core) indi-
cates that the set blast chilling temperature (+3°C) has been reached as signalled by an
intermittent beep for a minute. During the beep, LEDs 13 and 14 flash.
Display 16 indicates the temperature inside the cell, while display 15 shows
blast chilling time reset to zero.
• If at the end of the maximum blast chilling interval the core probe continues to display a tem-
perature higher than the value for the end of blast chilling, the displays will indicate an alarm
for excessively long chilling (ALL 14) alternating with the temperature and time; at the same
time, the alarm beep will be activated.
The blast chilling cycle continues until the end chilling temperature has been reached; dis-
play 15 counts back the minutes remaining until the end of the cycle.
NB: Press push-button 8 to mute the alarm; press push-button again to clear the
alarm display.
• At the end of the chilling cycle, the appliance automatically switches to the set storage tem-
perature for an indefinite interval (like a standard storage appliance).
NB: LEDs 13 switch off while LEDs 14 light up.
To Next Page
Loading...
