230 Series Auger Packer
35 OF 115
NON-INFLUENCING SPOUT
This design consists of a spout within a spout. This is to isolate the scale system from the feed coming
thru the fill spout.
It is used with materials that tend to build up or cake on the inside surface of the fill spout. This build-up
in a single wall spout would cause restriction on scale movement and cause weight variance.
WARNING: Only qualified technicians should perform maintenance on the non-
influencing spout.
Disconnect the power supply to the 200 Auger Flow during disassembly and re-
assembly of the non-influencing fill spout. Maintenance should NEVER be
performed with electrical power connected to the machine.
COMPONENTS OF A NON-INFLUENCING SPOUT
Outer Spout Tip
Wire retainer
Outer spout
Inner spout
Inner Spout retainer ring
Isolator seal
To Next Page
Loading...
