CD Automation CD3000 E-3PH - Page 55

CD Automation srl CD3000E-3PH from 25A to 500A User’s Manual
55
P112 (H70)

Digital output configuration (terminal 16) R/W
Function: This parameter selects the function of the digital output.
Value: 0 = Thyristor Failure
1 = Heater Break Alarm (HB)
2 = Unbalanced Load
3 = Current limit active
Default: 1
P113 (H71)

Digital output configuration (terminal 11 and 12) R/W
Function: This parameter selects the function of the digital output.
Value: 0 = Thyristor Failure
1 = Heater Break Alarm (HB)
2 = Unbalanced Load
3 = Low voltage
Default: 0
Note: Not available for size S09
P114 (H72)

Baud Rate R/W
Function: This parameter selects the Baud rate on the serial port.
Value: 0 = 4800
1 = 9600
2 = 19200
Default: 2
P115 (H73)

Address R/W
Function: This parameter selects the Address on the serial port for the thyristor unit.
Min/Max: 1 ÷ 127
Default: 1