To Next Page

To Previous Page

System Installation

Unboxing

1. View the Site Preparation Guide (P/N FM0050) and select a location that meets requirements before installing

the MARS 6 Synthesis instrument.

2. Carefully inspect the shipping carton, the instrument and accessories for any damage that may have occurred

during shipping. If the instrument or accessories have damage, contact the freight carrier to report the damage

and le a damage report. Contact your CEM representative to request service information.

WARNING

If any damage to the instrument is noted, do not attempt instrument operation.

3. Pull plastic tab, swing handle open and remove the plastic assembly from box. Repeat process on the remain-

ing handles.

4. Use top handles to pull up and remove outer box.

5. Carefully cut the tape on both sides of the inner box.

Questions and Answers:

Need help?

Do you have a question about the CEM MARS 6 Synthesis and is the answer not in the manual?

CEM MARS 6 Synthesis Specifications

General