To Next Page

To Previous Page

Hardware Installation

Header Icons

These icons are easily accessed and viewable from any screen, the header icons are quick looks for certain

ORACLE functions.

Main Menu

This icon contains access to all the primary functions of the ORACLE. See section “Main Menu” for additional

information.

Magnet Temperature

This icon indicates if magnet is operating out of optimal range. Red indicates that the magnet is above optimal

operating temperature and blue indicates that it is below optimal operating temperature. By pressing the “Magnet

Temperature” icon, a window will appear showing exactly how far off the temperature is from the optimal magnet

temperature

QuikPrep Temperature

This icon displays the actual temperature and set temperature of the QuikPrep heater at the top of the magnet.

The icon will display a red bar/up arrow when warming up, and a blue bar/down arrow when cooling down. The

QuikPrep heater will take approximately2 minutes to heat 10°C, and 10 minutes to cool 10°C

Trac Film Counter

This icon displays the number of tests the current roll of Trac Film has left.

SMART 6 Connection

This icon indicates if the SMART 6 is connected and communicating with the ORACLE software. This is only for

customers using the SMART 6 for rapid moisture analysis.

Balance Connection

This icon indicates if the CEM supplied balance is connected and communicating with the ORACLE software. The

balance is only for customers not using a SMART 6 for moisture content.

CEM ORACLE Manual

Other manuals for CEM ORACLE