37
Sample Preparation using the ORACLE Station
4. Position the wrapped tube and sample into the ORACLE tube. Carefully press the sample into the bottom of
the tube with the ORACLE Station press. Then press the sample rmly to ensure that the sample is positioned
in the appropriate analysis area. Check to make sure the sample is not positioned beneath the bottom of the
tube.
Sample Removal
1. After the analysis is complete, press the sample pads out of the ORACLE tube using the sample removal rod
and throw the used ORACLE pads in the trash.
2. Inspect tube for debris or damage.
• If debris is observed, wipe tube with damp cloth. Ensure tube is dry before continuing use.
• If tube is damaged (ie dented), dispose of tube.
To Next Page
Loading...
Need help?
General
