To Next Page

To Previous Page

Maintenance Procedures

NOTE

QuikPrep temperature should always at 45°C when not in use for sample analysis.

• Fat Bias - This will set a bias for every result produced by the ORACLE if necessary to match historic data.

CEM does not endorse or recommend the use of a bias.

• Sample mass precision - This will adjust the precision of the sample mass gathered by the external

balance for calculating sample weight before ORACLE analysis.

• Normalization Data - This will produce the raw signal data from the Normalization tests performed during

setup. This should only be accessed at the request of a CEM trained specialist.

System

The “System” settings are used to record and control ORACLE information and connections, along with basic user

interface controls.

• Magnet S/N - This logs the serial number for the ORACLE magnet should for record keeping.

• Processor S/N - This is where the serial number for the ORACLE Processor box should be logged for record

keeping.

• System Time - This is used to set the correct time for the ORACLE so it is accurately reected in sample

logs.

• Volume - This adjusts the volume of the speakers for videos and other auditory cues on the ORACLE.

• SMART 6 - This setting must be turned “ON” in order for the ORACLE to connect with a SMART 6 moisture/

solids analyzer. This setting should be “OFF” for high throughput users without a SMART 6.

• Automation: Use Robot - Setting this “ON” will allow the ORACLE to connect with the High Throughput

Robot option.

• Simulate Instruments - Turning this on will allow users to mimic the ORACLE performance without actually

running any samples, and is primarily used as a sales and demonstration tool.

• Service Mode - This will allow CEM trained specialists to have additional access to certain system

parameters and functions as necessary for servicing or optimizing the ORACLE.

• Screen Saver - This can be used to adjust the time in minutes until the ORACLE screensaver is activated

since the last time the touchscreen was touched.

• ‘Recent Results’ age lter - This will change the number of results that appear in the ‘Recent Results’

page.

CEM ORACLE Manual

Other manuals for CEM ORACLE