36
Sample Preparation using the ORACLE Station
Sample Preparation using the ORACLE Station
Sample Preparation using the ORACLE Station
The sample must rst be dried to remove any free moisture that may cause interference during analysis.
1. Remove and place one sheet of Trac Film on the platform of the ORACLE Station.
2. Place the square pad and sample in the center of the Trac Film.
3. Prepare the sample pad. Fold the left corner of the lm and pad as illustrated. Fold the right corner. Pull the
lower edge of the lm and sample pad toward the top and begin to roll them into a tube.
To Next Page
Loading...
