To Next Page

To Previous Page

Software Setup

5. Insert the CEM USB located in the Normalization Kit into the ORACLE Processor Box USB Port.

NOTE

Ensure the NS number on the Normalization tube matches that on the USB ash drive. If the two numbers

do not match, please contact CEM Corporation.

6. Once the USB is plugged into the ORACLE Processor Box, highlight the USB drive listed in the window and

select Import to complete the process.

7. Once the Clone le has been imported, select “Auto Run” to perform a full System Setup.

8. The ORACLE will prompt the user to “Please insert Oil standard tube” in the magnet. Place the glass Oil Stan-

dard tube into the magnet. Ensure the Oil Standard tube is completely placed down in the ORACLE by gently

pressing it down on the top.

9. Select “continue”.

Other manuals for CEM ORACLE

Questions and Answers:

Need help?

Do you have a question about the CEM ORACLE and is the answer not in the manual?

General