CEM SMART System 5 User Manual

47
Note: The method test screen appears indicating
the power, temperature and time.
15. If Autotrack is turned off, a method
identification name or number is required.
Press the operation key below ID.
16. Using the operation keys below the arrows,
position the cursor on (select) the first
number or letter of the sample identifi-
cation. Press ENTER. Continue to position
the cursor on each letter or number and
press ENTER until the identification is
complete.
Note: If using an identification number only, use
the numeric keys to enter the number.
17. Press READY to return to the method
screen.
18. Lift the top cover of the SMART System
5™. Place two glass fiber sample pads on
the balance pan. Close the top cover.
19. Press TARE.
20. Wait for the instrument to tare the weight
of the sample pads. The method test screen
will reappear when the tare function is
complete.
XXXXXX
Power: xxx %
Temp (xxx): xx.x
Time: xx:xx
Wt: x.xxxxg
Place pads on balance and
press TARE.
ID
1 2 3 4 5
SAMPLE ID:
0 1 2 3 4 5 6 7 8 9 A B
C D E F G H I J K L M N
O P Q R S T U V W X Y Z
Space Delete
Highlight choice, press ENTER.
Press READY to continue.
➞
➞
➞
➞
TARING BALANCE . . .
XXXXXX
Power: xxx %
Temp (xxx): xx.x
Time: xx:xx
Wt: x.xxxxg
Place pads on balance and
press TARE.
ID SOLIDS
1 2 3 4 5

CEM SMART System 5 Specifications

General

Brand	CEM
Model	SMART System 5
Category	Measuring Instruments
Language	English