How to fix waste pump tubing leaking in CEM SPRINT?
If the waste pump tubing is leaking in your CEM Analytical Instruments, it's likely due to an incorrect tubing size. Replace it with the correct tubing size.
What to do if my CEM SPRINT Analytical Instruments are not seeing the firmware?
If your CEM Analytical Instruments are not seeing the firmware, it could be due to a couple of reasons. First, check if the USB cable is unplugged from the CPU board and plug it in. Second, make sure that the firmware is located in the correct directory (CEM/Sprint/Install).
General| Brand | CEM |
|---|---|
| Model | SPRINT |
| Category | Analytical Instruments |
| Language | English |
Explains the meaning of warning and caution notes used in the manual for safety and operational guidance.
Details the step-by-step procedure for performing an analysis using the SPRINT® instrument.
Guides the user through connecting and configuring an external balance with the Sprint instrument.
Details how to prepare the necessary iTAG and cleaning solutions for the instrument.
Provides instructions on how to properly install the homogenizer assembly into the instrument.
Describes how to configure the external balance type and its communication settings.
Describes how to select and load a pre-defined analysis method.
Guides on how to modify existing analysis methods.
Describes how to set method name, bias, and result precision.
Details how to set sample weight and protein parameters.
Explains how to configure homogenization, filter height, delay, and settling times.
Describes how to add and manage calibration reference points for a method.
Guides on performing routine maintenance tasks like cleaning and system checks.
Details daily, weekly, monthly, and quarterly maintenance tasks.
To Next Page
