page 35 www.centsys.com
8.1. Secure Vx SMART Wall Box to Wall
Secure the Vx SMART Wall Box to
the wall using the most appropriate
means.
Be sure to position the Wall Box so
as not to cause any hazards during
and after the installation. Preferably
mount the Wall Box:
FIGURE 38
Mount the Vx SMART Wall Box preferably at
a comfortable working height
• Out of direct sunlight
• At a comfortable
working height
• Away from garden
sprinklers, etc.
• To allow easy access
even when the gate is
open
ELECTRICAL SETUPSECTION 8
8. ELECTRICAL SETUP
ATTENTION!
1. Always check that the circuit breaker in the electrical panel is in the
OFF position, and that all high-voltage circuits (more than 42.4V) are
completely isolated from the mains supply before doing any work.
2. Ensure that all low-voltage systems (less than 42.4V) are suitably protected from
damage, by disconnecting all sources of power such as chargers and batteries
before doing any work.
3. All electrical work must be carried out according to the requirements of all
applicable local electrical codes.
To Next Page
