20
Restores all the user access codes as well as system settings
from the optional CP108 Backup Memory Module.
Procedure for restoring the unit:
Remove power. Plug the CP108 into the socket provided.
Reapply power. All three LEDs will now be on. Press 3 on the
keypad. The YELLOW LED will begin to flash, indicating that
the memory is being restored. When the restore is complete, a
beep will be heard, and the YELLOW and GREEN LEDs will
turn off. Remove the Memory Module, and keep it in a safe
place.
Note:
!
Restoring from a Memory Module will overwrite any
information that was previously contained in the
SmartGUARD unit. In addition, the master code will be reset
to 1234.
Restoring the unit
To Next Page
Loading...
