21
Both the master code and the system parameters (timers,
alarm functions etc.) can be reset to factory defaults. This is
useful when the master code has been forgotten, or the system
parameters are in an unknown state.
Defaulting the Master Code:
Remove power. Re-apply power while holding the 1 key down
for 2 seconds. A beep will then follow, indicating that the master
code has been reset to 1234.
Defaulting the System Parameters:
Remove power. Re-apply power while holding the 2 & 3 keys
down for 2 seconds. A beep will then follow, indicating that the
system parameters have been reset to the following factory
defaults:
Output timers: 1s pulse
Wrong codes: 3
Wrong code reset: 60s
Wipeout timer: 15s
Security parameters: All OFF
NOTE:
!
Defaulting is not possible if the anti-default option has been
set (see page 16). In this case, if the master code has been
lost, the system must be restored from a backup to reset the
master code to 1234.
Defaulting the unit
To Next Page
Loading...