26
Glossary
ACCESS CODE
The code number the user will enter to gain access. It can
range in length from 1 to 10 digits.
ADDRESS / USER ADDRESS
The location where the user's code is stored in the keypad
memory. It can be any number between 1 and 999. It should
be recorded, allowing the user code to be removed from the
memory later if necessary.
MASTER CODE
The code number required for programming the keypad. It is
stored in user address 0. THE DEFAULT MASTER CODE
OF A NEW UNIT IS 1234. FOR SECURITY REASONS, THE
INSTALLER SHOULD CHANGE THIS CODE AT THE TIME
OF INSTALLATION. Refer to page 5 for instructions on how
to change the master code.
ENTER KEY #
In order to gain access, the user code must be followed by a
#.
To Next Page
Loading...
