Page 31
III. Press and hold the “Learn” Button (Figure. 19-D) for two seconds in order to
initiate Forced Learn – LED Indicator will begin to quick flash
IV. Rotate the (red) “Speed” Adjustment Pin (Figure.19-F) in a clockwise direction
to increase running speed and anti-clockwise to decrease running speed
V. Close the Courtesy Lamp cover once adjustment has been completed
Running speed may only be adjusted while the Drive Unit is travelling between
Limit Points.
Speed Control adjustment will close out automatically once the Drive Unit reaches
either one of the Limit Adjust Prongs.
5.19 Maintenance
Once every six months;
I. spray the inside vertical faces of the Drive Rail along the entire length with a
light coating of Ballistol lubricant only (CENTURION part number
OIL1302X30ML).
Important Note: Using any other type of lubricant may cause the XTrac to
malfunction!
II. disengage the XTrac from the door (Figure.11) and then test the door to ensure
that it meets with the requirements detailed on page 1, Items 3 and 4.
To Next Page
Loading...
