Cervis TM70 User Manual

System User Manual
2007-2016 Cervis, Inc.
19
4.4 Programming the Machine Identification in LCD Transmitters
Transmitters with the optional LCD display permit the operator to program a machine
identification label of up to 24 characters. The identification displays upon transmitter
start-up.
You can edit/introduce this text as follows when first starting the transmitter (see Figure
12):
1. Install a battery and turn the ON/OFF key to ON.
2. Push in and then pull out the STOP Button. You the LED should pulse
orange followed by green pulses.
3. Press pushbutton 4 to the second step and then push the START
Button. Keep both pressed simultaneously for 2 seconds. You will enter
the EDITING mode.
4. Once you have entered the EDITING mode, the display will show
CRANE ?? with the first character blinking. From this point you can edit
the name of the machine using pushbuttons 1 to 4. Button functions are
as follows:
 Pushbutton 1: Scroll the list of established characters in descending order.
 Pushbutton 2: Scroll the list of established characters in ascending order.
 Pushbutton 3: Return to the previous character in the display.
 Pushbutton 4: Validate the displayed character and move to the next
character to the right.
 Push START to store the edited text. LCD will show the message SAVED
for two (2) seconds.
5. Once the last character has been edited, exit EDITING mode by pressing
the STOP Button.
Figure 12. Transmitter Button Locations

Cervis TM70 Specifications

General

Brand	Cervis
Model	TM70
Category	Remote Control
Language	English