Cervis TM70 User Manual

TM70 Handheld Wireless Remote Control
U003.6.0-TM70_HH_SYS-R
20
4.5 LCD Display Analog Feedback Calibration
Analog feedback systems must have the Display and Analog Feedback options. The
analog input must be calibrated upon startup. Transmitters with the display option allow
the operator to calibrate the analog input using the display three digit value and a
comma; and, a measurement unit of up to three characters.
 Note: Calibration generates a linear interpolation of the possible values. This means
that it can be used with all systems that generate a linear analog output. For
non-linear systems, the interpolation will display an incorrect value.
4.5.1 Calibrating Analog Feedback
The transmitter must be within operating range of the receiver during this
procedure.Use Figure 12 to reference pushbutton and key switch locations on the
transmitter.
1. Insert a fully charged battery into the transmitter and turn the Key Switch
to ON.
2. Push and then pull-out the STOP Button.
3. Place a known load on the crane to introduce the first value.
4. Enter the Calibration mode by pressing Pushbutton 4 to the second
speed; continue to hold the button down.
5. Push and hold the START Button simultaneously with the pushbutton 4
until CONFIG appears on the display.
6. Press Pushbutton 4 to enter the MENU.
7. Use Pushbuttons 1 and 2 to navigate through the menu until you find
CALIBRATION.
8. Press Pushbutton 4 again. You will enter a Calibration submenu where
you can navigate to selections Value 1, Value 2, and Units by using
Pushbuttons 1 and 2.
9. Navigate to the desired submenu, Value 1, and press Pushbutton 4 to
enter that submenu. Note that the receiver will start up, but you will not
have control over crane motion. The transmitter must communicate with
the receiver in order for the information from the analog input to be sent to
the transmitter. While in a submenu, you can use Pushbuttons 1 through
4 as follows:
 Pushbutton 1 – Used to move through character list in descending order.
 Pushbutton 2 – Used to move through the character list in ascending order.
 Pushbutton 3 – Used to return to the previous character in the list.
 Pushbutton 4 – Used to select the chosen character for that digit position
and move to the next digit position.
10. Once a corresponding value is assigned to the suspended load, the
display will show three digits plus a comma. Make sure the value
displayed is accurate.

Cervis TM70 Specifications

General

Brand	Cervis
Model	TM70
Category	Remote Control
Language	English