CET PMC-340 - Page 19

CET Inc.
19
Configuration. Once inside Setup Configuration, pressing <↩> either enters a sub-
menu or selects a parameter for modification. If inside a sub-menu, pressing <↩> for
two seconds will return to the main menu. If a parameter is selected, its value will blink
while it’s being changed. If the parameter is a numeric value, pressing <↩> will move
the cursor one digit to the left. When the left most digit has been reached, pressing <↩>
again will save the current value into memory.
<▼>: Once inside Setup Configuration, pressing <▼> scrolls to the next setup parameter or
sub-menu. If the selected parameter is a numeric value, pressing <▼> increments the
current digit. If the selected parameter is an enumerated value, pressing <▼> scrolls
to the next item in the enumerated list. When finished, press <↩> to save the current
value into memory.
Making setup changes:
 Press <↩> for two seconds to enter Setup Configuration, and the LCD displays PROGRAM.
 Press <▼> to advance to the Password page.
 A correct password must be entered before changes are allowed. The factory default
password is 0000 (zero). Press the <↩> button to select the parameter for modification. Use
<▼> and <↩> to enter the correct password.
 Use <▼> to scroll to the desired sub-menu or setup parameter.
 Press <↩> to enter a sub-menu or select a setup parameter for modification.
 Once a parameter has been selected, its value will blink.
 Use <↩> and <▼> to make modification to the selected parameter.
 Press <↩> for two seconds to return to the main menu
 Press <↩> for two seconds again to exit the Setup Configuration mode.
Also the Setup Configuration will be automatically exited if there is a period of inactivity of 3
minute or longer.