Table 5-27 Communication Setup
Notes:
1) If the Baud Rate is set to an invalid value, it will default to 9600bps automatically.
5.11 Data Recorder Setup (PMC-340B Only)
Table 5-28 Data Recorder Setup
Notes:
1) Changing any of these Data Recorder setup registers will reset the Data Recorder.
2) Recording Offset can be used to delay the recording by a fixed amount of time from the
Recording Interval. For example, if the Recording Interval is set to 3600 (hourly) and the
Recording Offset is set to 300 (5 minutes), the recording will take place at 5 minutes after the
hour every hour, i.e. 00:05, 01:05, 02:05…etc. The value of the Recording Offset parameter
should be less than the Recording Interval parameter.
3) Please refer to Appendix A for a complete list of Data Recorder Parameters.
5.12 TOU Setup
5.12.1 Basic
To Next Page
Loading...
Need help?
General
