19
Supervisor Mode
SUPERVISOR MODE
MACHINE SETTINGS
• Press DWELL button to set dwell settings.
• Range is 1-999 seconds.
• The factory default setting is 15 seconds.
Delime Settings:
Dwell Settings:
Fig. 37 - Machine Settings
CAUTION:
Machine settings should not be changed without the approval of authorized service.
• Press DELIME button ON or OFF.
• Factory setting is 100 hours between deliming.
• Factory setting is a 10 minutes delime wash.
• Factory setting is a 10 minutes delime rinse.
• Press the number to change the setting.
Fig. 38 - Dwell Settings
Fig. 39 - Delime Settings
Language Settings:
• Factory default setting is ENGLISH.
• Press ENGLISH to change
to Canadian FRENCH.
Fig. 40 - Language Settings
Continued on next page.
To Next Page
