Chattanooga Continuum - Unlocking and Compliance Data

EN
22
PRODUCT INFORMATION CLINICIAN
Additional Lockout Feature
There is an additional lockout feature that the clinician can
use to remove the option of a treatment from the screen
so that the patient does not have the option of selecting a
particular treatment type.
It can be accomplished as follows:
. On the main options screen, press “CONFIG” to get to
the CONFIG menu
. Press “LOCKS” (Lower Right Soft Key).
. Using the Left Soft Keys, scroll down to one of the four
lock items (NMES L.MUSCLES, NMES S.MUSCLES and
TENS).Then, using the upper right hand soft key, scroll until
a forbidden icon is shown.
. Press the “Home” button to get back to the main menu.
Notice that the therapy option has been removed from
the display.
Unlocking the Device
When the Chattanooga Continuum is locked, it allows the
clinician to control the patient’s use of the device to assure
access to only the pre-selected protocol.
“Unlocking” the device gives the clinician the ability to set
up a new treatment protocol.
To “unlock” the device, perform the following steps:
. Press the ON button to turn on the device, or press the
Home button.
. Once the main Options menu is displayed, choose
“CONFIG” option.
. Choose the “LOCKS” option.
. Using the Left Soft Keys, scroll down to a lock items
(NMES L.MUSCLES, NMES S.MUSCLES and TENS).
. Use the lower right side soft key to scroll the item’s value
until an “unlock” icon is shown.
. Press the Home button to return to the main menu.
View & Reset Compliance Data
The Chattanooga Continuum monitors patient usage
of the device. This feature helps determine patient
compliance with the selected protocol(s).
The following information is collected:
• Number of total sessions
• Total session time (hours)
• Average session time (minutes)
• Average Channel  Intensity
• Average Channel  Intensity Product
Information
To View the aforementioned Compliance Data, the
following steps are to be applied:
. Press the ON button to turn on the device.
. Once the main Options menu is displayed, choose
“CONFIG” option.
. Choose the “data” option (upper right soft key).
. Use the left side soft keys to scroll through the data.