CHCNAV i70+ - Page 33

Front Panel Operation
33
button to cancel the change
and back to the second-level
menu.
Port 9901
 Click Enter button to change
the port from 9901 to 9920.
OK
 Click Enter button to save the
settings and back to the
top-level menu, and then this
combination working mode
will take effect.
Cancel
 Click Enter button to cancel
the settings and back to the
second-level menu.
Rover APIS
 Set up the receiver as a rover
station using APIS service.
 Click Enter button to enter the
configuration screen.
Mode Rover APIS
 The title of this configuration
screen.
Current Base SN 1000456
 Display the SN of
corresponding base station.
 Click Enter button to enter
Base SN setting screen. In the
Base SN setting screen, click
Fn button to move to the
character of the value you
want to make change, and
then click Enter button to
change from digital 0 to 9 (in
addition, the initial character
can be changed to letter R).
After the change has been
done, you can click Fn button
to move to OK field, and then