Check Point R80.20 - Cpstat

Command Line Reference
Next Generation Security Gateway Guide R80.20 | 348
cpstat
Description
Displays the status and statistics information of Check Point applications.
Syntax
cpstat [-d] [-h <Host>] [-p <Port>] [-s <SICname>] [-f <Flavor>] [-o <Polling
Interval
> [-c <
Count
>] [-e <
Period
>]] <
Application Flag
>
Note - You can write the parameters in the syntax in any desired order.
Parameters
Parameter Description
-d
Optional.
Runs the command in debug mode.
Use only if you troubleshoot the command itself.
The output shows the SNMP queries and SNMP responses for the
applicable SNMP OIDs.
-h < Host >
Optional.
When you run this command on a Management Server, this parameter
specifies the managed Security Gateway.
<
Host > is an IPv4 address, a resolvable hostname, or a DAIP object name.
The default is
localhost
.
-p < Port >
Optional.
Port number of the Application Monitoring (AMON) server.
The default port is 18192.
-s < SICname >
Optional.
Secure Internal Communication (SIC) name of the Application Monitoring
(AMON) server.
-f < Flavor >
Optional.
Specifies the type of the information to collect.
If you do not specify a flavor explicitly, the command uses the first flavor in
the <
Application Flag >. To see all flavors, run the cpstat command
without any parameters.