Chemitec 4204 - 1 General; Manual Information; Conventions

4204
FLOW METER
TECHNICAL MANUAL P/N XXX-0000 Rev. 5 Ver. 3.4
1
1 GENERAL
1.1 MANUAL INFORMATION
This document contains copyrighted information. They may be subject to modifications and
updates without notice.
Printing sequence
First edition: µACP 4204 – Rev. 0 Ver 1.1
This manual is integral part of the instrument. At first installation of the instrument, the operator
must carry out an accurate verification of the content of the manual in order to verify its integrity
and completeness.
In case it shows to be damaged, incomplete or unsuitable, please contact CHEMITEC in order to
immediately integrate or replace the non-complying manual.
The official versions of the manual, for which CHEMITEC is directly responsible, are the Italian
and English versions. For Countries with languages different than those versions above mentioned,
the official manual in the one in Italian language. CHEMITEC shall not be held responsible for any
translations in different languages carried out by distributors or users.
Compliance with the operating procedures and warnings described in the present manual is an
essential requirement for the correct operation of the instrument and to guaranty safety for the
operator.
Before installing/operating the instrument, the manual must be read in its entirety while standing in
front of the same, in order to become very familiar with the operating procedures, controls,
connections to peripheral instruments and precautions for the safe and correct use of it.
The user manual must be saved, integral and legible in all of its parts in a safe place and, at the
same time, quickly accessible to the operator during installing operations, use and/or reviewing the
installation
1.1.1 CONVENTIONS
This manual utilises the following printing conventions:
NOTE
The notes contain important information to be emphasised with respect to rest of the text.
They generally contain information useful for the operator in order to execute correctly and
optimise the operating procedures.
WARNING
Warning messages appearing in the manual before procedures or operations which must be
respected in order to prevent possible loss of data or damages to the instrument.
CAUTION
Caution messages appear in the manual near descriptions of procedures or operations
which, if carried out incorrectly, may cause damages to operators or users.