Limitation of Engine Speed
The engine speed is limited by electronic device (ECU) to
protect the engine.
Engine Flameout
Release the accelerator pedal. Wait for the engine to
reduce to the idle speed, and then shut down the ignition
switch.
Don’t step on the accelerator pedal before
stopping the engine.
For parking after long-time traveling at high speed, don’t
stop the engine immediately; let the engine operate another
2 minutes at the speed higher than idle speed, in order to
make the temperature decrease gradually.
After the ignition switch is turned off to stop the
engine, the engine temperature is still high, and the
electronic cooling fan of radiator will continue to operate for
about 10 minutes. Even though the cooling fan stops
operation, it may operate again because of the high
temperature. Therefore, you have to be cautious when
working beside the engine.
Remove the blocks of snow, leaves and other
foreign materials at vent, in order to ensure the ventilation
effect of vehicle.
Adaptive Function of the Engine
Control System
If the battery wire was once removed from the battery, there
may be some abnormal phenomena at the very beginning
of the traveling after reconnection. This is because the
engine control system is relearning to adapt to the engine,
which is normal.
To Next Page
Loading...
Need help?
General
