Parameters of Capacity and Specifications
If the oil contacts the paint
surface, please wipe out the oil with
the wet sponge or rinse the paint
surface with plenty of water.
The brake fluid reservoir pot is located
at the left rear of engine compartment.
The oil level should stay between MAX and
MIN signs at the side of oil tank. If the
oil level drops at the MIN sign, the brake
system warning light on instrument panel
will lighten.
Only add the brake fluid in line with the
specification of Chery (see the chapter
“Capacity and Specification”). Send it
to the special service station of Chery
for the inspection of system leakage as
soon as possible.
It is important to ensure the absolute
cleanness in case of adding the brake
fluid.
Do not let the brake fluid contact
your skin or eyes. Providing such an
unlucky occasion is encountered, please
clean the affected parts with plenty of
water and immediately seek the medical
treatment.
Do not open the filling cover in
the event of a running engine or the high
temperature. Otherwise, the coolant may
eject from the system to result in the
Inspect the coolant level through the
translucent reservoir. When the engine is
in the cold state, the coolant level
should be between MIN and MAX signs. When
the engine is hot, the coolant is likely
to exceed the MAX sign due to the
expansion.
The coolant can be added if the engine is
cold. If it is necessary to add the coolant
in the presence of a hot engine, first of
all, wait 10 minutes to let the engine cool
down. Unscrew the cover of reservoir for
a quart of circle to discharge the
pressure. Wait for a period of time and
then open the cover fully. Add the coolant
in line with the specification of this
vehicle.
To Next Page
Loading...
Need help?
General
