Parameters of Capacity and Specifications
It is strongly advised that you use the
original tyres or refer to the special
service station of Chery when installing
the tyres.
The speedometer is affected by the size of
tyres used for the vehicle. If the tyre
size (diameter) is different from the
original one, the correct speed will not
be shown.
The unsuitable tyres and rims may
lead to an accident, which are not
within the scope of warranty.
If you want to install the
non-standard tyre or rim, (such as the
light alloy rim or wheel of winter
tyre), be sure to comply with the
instructions or consult the special
service station of Chery.
Anti-skid Chain for Snowy Ground
The anti-skid chains for snowy ground can
be used for summer and winter tyres, but
are only applicable to the driving wheels
(i.e. front wheels).
When the anti-skid chains for snowy ground
are in use, the traveling performance of
vehicle equipped with the anti-skid
control system may have some anomalies
which can be eliminate by shutting down
this system.
In order to avoid the damage to the
full-diameter wheel cover, it this cover
should be removed before installing the
anti-skid chains.
The wheel cover should be installed back
as soon as the anti-skid chains have been
removed.
1. When using the anti-skid
chains, be sure that the vehicle speed
shall not exceed 50 km/hour.
2. The anti-skid chains should be
removed immediately in the absence of
snow on the road.
Wheel Train Belt
The driving belt is one of the parts
stressed most seriously in the vehicle, so
the quality of belt should be good and
reliable to meet the work requirements.
When replacing the driving belt, only
choosing the belts of the same size can not
meet the requirements. For the sake of
safety, be sure to use the original belt
of Chery. Special service stations of
Chery have the original driving belts.
Attention:
The driving belt will elongate after
being used for a certain period of time.
When the elongation is up to a certain
degree, the belt will be so loose that it
may cause the damage to the vehicle
Therefore, it is necessary to inspect the
tensity of generator belt every time the
vehicle has covered a 1,000km.
To Next Page
Loading...
Need help?
General
