Parameters of Capacity and Specifications
Engine Jump-start Method
If the battery of the vehicle has no power, battery
power of other vehicles can be input to help the
engine to start.
Only a battery of the same nominal voltage (12V)
can be connected. Use jump leads with insulating
clips and cables of proper sizes. Please do not
disconnect the battery from the electrical system of
the vehicle.
Connect Lead
1. Park the vehicles properly so that they do not
contact each other.
2. Stop the engine and any other unnecessary
electrical devices.
3. Connect the positive (+) terminal of the low
battery with the positive (+) terminal of the
supporting battery using lead A.
4. Connect one terminal of lead B with the
negative (-) terminal of the supporting battery,
and then connect the other terminal of lead B
with the metal part of the engine to be started.
Position the jumper leads to prevent it from
contacting the running parts of the engine
compartment.
The negative (-) terminal of the low
battery shall not be connected with.
5. Make sure that the jumper cables do not
interfere with the running parts of the engine.
Start Engine
1. The engine of the vehicle with the supporting
battery shall run at a properly high speed.
2. Start the engine of vehicle with the low battery.
Try to start the vehicle with the low battery
within one minute.
To Next Page
Loading...
