Parameters of Capacity and Specifications
Maintenance of Leather Veneer
Use the wet cotton cloth and towel to wipe
the leather surface, and use the clean
soft cloth to dry it. The very dirty
surface can be cleaned by neutral
cleanser, such as soap bubble agent.
During the normal usage period, it is
recommended to take the leather
maintenance with special leather
conservation agent once six months.
Do not make leather too wet. Especially,
do not let water into the gap.
Only the proper leather cleaning
materials and cleanser can be used.
Cleaning of Radiator
The windward surfaces of condenser and
radiator will be blocked by some insects,
leaves and other debris after
whole-vehicle moving for a period of time.
In this case, the blockage will affect the
performances of air conditioner and
cooling system and lead to the abnormal
operation of air conditioner and the
overheating of cooling system etc. Thus,
it is required to clean the radiator and
condenser.
It is better to clean the obverse surface
of radiator once a year. The compressed
air or water can be used to clean the
radiator fins and blow off the small
leaves and insects etc. The condenser can
be washed by the forward blowing through
radiator.
The pressures of air and water shall not
exceed 150 kPa. The pressure higher than
150 kPa would damage the condenser and the
radiator fins.
The radiator fins are necessary to
the good heat conduction. These fins can
not be brushed. Or else, the damages to
fins will be caused and the heat
conduction will be reduced.
In no case shall you spray the water on
the hot radiator, because the hot air
generated will lead to the body injury.
Only when the engine is not working and
cool can the water be used to wash.
To Next Page
Loading...
Need help?
General
