Parameters of Capacity and Specifications
Replacement of Wiper Blade
Raise the wiper arm and make it form a
right angle with the wiper blade. To
remove the wiper blade, please press the
fixing clip according to the direction
shown by arrow, then release the wiper
blade, and finally pull out the wiper arm
according to the opposite direction.
Tyre
For your safety, please check the tyre
pressure after the tyres (including spare
tyre) become cold. See the proposed tyre
pressure in the chapter “Capacity and
Specification”.
The correct tyre pressure should be
complied with especially during the
high-load and high-speed running. The
insufficient tyre pressure will
reduce the stability, increase the
rolling resistance and advance tyre
abrasion and even lead to the
accident.
If you need to drive the vehicle on the
curb, you have to keep a low running
speed, and if possible, make the
wheels close to curb at right angle.
Avoid the vertical and sharp
obstructions. When parking the
vehicle, do not have the side wall of
tyre scratched.
Regularly inspect tyre surface for
cut trace, foreign body and uneven
wear. The uneven tread wear may
indicate the incorrect alignment of
wheel.
The worn depth of tread is limited in relevant
laws and regulations. Notice that: when the
worn depth reaches the limiting value of 3mm,
the worn areas will appear on the tread, which
indicate that the performance and security of
tyre has greatly degraded and the tyre must be
replaced.
The worn tyres should be treated under
local environmental protection provisions.
Once the road conditions allow, the winter
tyres should be immediately changed with
summer ones. This will reduce the fuel
consumption and the noise.
Regularly interchange the tyres. It is
recommended to interchange four wheels for
every 5,000 km. Namely, interchange left
front tyre with the right rear tyre, and
interchange the right front tyre with the
left rear tyre.
Replacement of Tyre
The tyres used by your vehicle are properly
chosen to provide the best vehicle control,
comfort and safety. The above-mentioned
combined provisions of tyre and rim are
applicable to the steel or aluminum alloy wheel
rim. If you want to know whether other types
To Next Page
Loading...
Need help?
General
