6 Commissioning
6.1 Using the Start Up Wizard
Commissioning the VariPro controller is easy: The Start Up Wizard guides you
through the first step, and the units detected are then automatically configured.
The various control modes can be defined after that.
The Start Up Wizard is started automatically when the controller is turned on for
the first time.
Note! If you need to start the Start Up Wizard again later, select Unit
settings→Scan from the controller’s menu.
1. Select FAN to begin scanning.
2. Wait for the scanning result.
Copyright © 2021. All rights reserved.
20 (37)
N03104128 Rev. A VariPro Room controller – Installation and Operation Manual
To Next Page
Loading...