8 Installer Setup Menu
Press and hold the Connect, Info, and Cancel buttons (at the same time) for three seconds, to access the Installer
Setup.
+ +
SEVEN will beep three times and announce “Installer Setup”, followed by the first option in the menu that you have
the option of changing. The installer setup options available are determined by the configuration file applied to
SEVEN. The options have been preselected by your organisation, so some may not be available to change.
• The Help button will be lit which indicates that it can be pressed to change a setting.
(The value is saved each time it is changed.)
• The voice message with the current value applied will repeat if left for ten (10)* seconds.
• Any volume setting voice announcement will be followed by a beep to indicate the volume level.
• Press the Cancel button to move to the next setting in the menu.
• To exit, press the Power button.
If left, the Installer Setup Menu will timeout after two (2) minutes.
8.1 Installer Setup Options:
Depending on the configuration file applied to SEVEN, some of these settings may not be included in the Installer
Setup Menu. Volume level is not spoken, beep indicates audio level.
Note: The Installer Setup Menu options are designed to be used during installation to make customer specific changes
to SEVEN. Additional changes to SEVEN operation can be made remotely through the Chiptech Wizard software.
To Next Page
Loading...
