Chore-Time FLEX-AUGER 108 Installation Manual

Model 108 FLEX-AUGER Installation Manual
( 37 )
Figure 22. Model 108 PVC Straight-Thru Tandem System.
Key Description
1 PVC Elbow
2 Tube Insert
3 Straight-Thru Boot (Intermediate Bin)
4 Tube Connector
5 10’ (3 m) PVC Auger Tube
6 Straight-Out Boot (Terminal)
3. See Figure 23: Steel Model 108 FLEX-AUGER systems.
Slide the belled end of the pipe over the outlet end of the
Straight-Out Boot.
Cut the straight end of the auger tube even with the inlet end of
the Intermediate Boot. Secure this joint using a Connector and
clamps.
Slide the belled end of the Elbow over the outlet end of the
Straight-Thru Boot. Secure in place using a Tube Coupler and
clamps.
4. Install the remaining auger tubes in the system. Remember to
caulk all tube joints exposed to the weather or moisture.
5. Install the auger and Anchor and Bearing Assembly as specified
in the installation section of the standard Model 108 Flex-Auger
system.
Stretch the auger in the same way you normally would for the
standard installation (8 inches per 50 feet or 200 mm per 15 m)
and cut it even with the rear of the straight-out boot.
6. Use a tube clamp to secure the bearing to the boot.

Chore-Time FLEX-AUGER 108 Specifications

General

Brand	Chore-Time
Model	FLEX-AUGER 108
Category	Industrial Equipment
Language	English