Chore-Time FLEX-AUGER 108 - System Wiring Diagrams

Model 108 FLEX-AUGER Installation Manual
( 39 )
Electrical Component Location Diagram for
Single Boot Systems using a Hopper Level Control
Important: If an Agri-Time Time
Clock is to be used, refer to MA1061
Instruction for control wiring.
If an Auger Timer is to be used, re-
fer to MA951 Instruction for control
wiring.
Important: If system is to be
controlled by a Proximity Drop
Tube Switch, refer to MA1044
Instruction for switch wiring.
If the system is to be controlled
by a mechanical Drop Tube
Switch, refer to MA1099 In-
struction for switch wiring.
Wiring Diagram for
Model 108 Systems using a Hopper Level Control Switch
(1 H.P. or smaller - Single Phase)
Note: Use this graphic along with each of the wir-
ing diagrams in this manual to assist in determining
switch, power unit, and control unit locations.