EasyManuals Logo

Chore-Time FLEX-AUGER 108 Installation Manual

Default Icon
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
Model 108 FLEX-AUGER Installation Manual
( 7 )
The 30 Degree Boot (left) is the standard boot used in
single bin applications.
The Straight-Out Boot (right) may be used in multiple
bin applications, elevated bins, and systems with less
free flowing feed stuffs.
The Hopper Level Control
is used to control the feed
level in the hoppers.
The Control Unit
(right) is located at
the end of the fill
system. A Power
Unit (left) is secured
to the Control Unit to
turn the auger.
An Extension Boot (optional) may be used to provide
additional length to a system. Multiple Extension Boots
may be used on very long systems.
An Outlet Drop is located at each
outlet opening along the FLEX-AU-
GER auger line.
The fill system may be controlled by the Drop Tube Switch (left)
or the Proximity Level Switch (right). Both switches are optional
and must be ordered separtely.
The 30 Degree Two Motor Tan-
dem Boot (optional) is used
when a cross auger is required
under two feed bins. This allows
the feed bins to be set at a 90
degree angle to the FLEX-AU-
GER feeder line.
Glossary of Terms
The Auger Timer (optional) is
used to control the length of au-
ger run-time. It may be used as
a safety backup to prevent ex-
cessive run time.
The Lower Boot
Components, locat-
ed under the feed
bin, include a bear-
ing and feed re-
strictor.

Other manuals for Chore-Time FLEX-AUGER 108

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Chore-Time FLEX-AUGER 108 and is the answer not in the manual?

Chore-Time FLEX-AUGER 108 Specifications

General IconGeneral
BrandChore-Time
ModelFLEX-AUGER 108
CategoryIndustrial Equipment
LanguageEnglish