7. Wait for the beep, and then dictate any message up to 140 characters. If you exceed 140
characters, you will hear the following prompt: “Message was too long; your message will be
truncated.”
8. Uconnect will then repeat the message back to you.
9. Uconnect will prompt you: “To add to your message, say “Continue”; To delete the current
message and start over, say “Start Over”; to send the current message, say “Send”; to hear the
message again, say “Repeat”.
10. Ifyou are happy with your message and would like to send it, wait for the beep and say “Send”.
11. Uconnect will then say “Sending your message.”
Sample Commands For Voice Text Reply And Voice Texting
Example Command Action
“Text John Smith”
Send a message to specific contact in address
book
“Text 123 456 7890”
Send 123 456 7890 a message from your phone-
book
“Show messages”
See recent text messages listed by number on
Uconnect screen
“Listen to/view (message number four, for ex-
ample)”
Hear messages or read it on Uconnect screen
“Reply” Send a voice text reply to a current message
“Forward text/message to “John Smith”
Forward current text to specific contact in ad-
dress book
“Forward text/message to “123 456 7890” Forward current text to specific phone number
ELECTRONICS
86
To Next Page
Loading...
