13
INSTALLATION MANUAL PRORAPID |
Safety Instructions
EU-Conformity
By axing the CE mark to the unit the
manufacturer declares that the SLC
conforms to the following relevant safety
regulations:
• EU low voltage directive 2014/35/EU
• EU electromagnetic compatibility direc-
tive 2014/30/EU conforms.
Conformity has been veried and the
corresponding documentation and the EU
declaration of conformity are kept on le by
the manufacturer.
General instructions
Please read carefully!
These installation and operating instructions
contain basic instructions and important
information regarding safety, installation,
commissioning, maintenance and the
optimal use of the unit. Therefore these
instructions must be read and understood
completely by the installation technician/
specialist and by the system user before
installation, commissioning and operation of
the unit.
This unit is an automatic, electrical Storage
Loading Controller. Install the unit only in dry
areas and under the ambient conditions
described in “Specications”.
The valid accident prevention regulations,
VDE regulations, the regulations of the
local power utility, the applicable DIN-EN
standards and the installation and operating
instruction of the additional system
components must also be observed.
Under no circumstances does the unit
replace any safety devices to be provided by
the customer!
Installation, electrical connection,
commissioning and maintenance of the
device may only be carried out by an
appropriately trained specialist. Users: Make
sure that the specialist gives you detailed
information on the function and operation of
the unit. Always keep these instructions in
the vicinity of the unit.
The manufacturer does not take over any
liability for damage caused through improper
usage or non-compliance of this manual!
To Next Page
Loading...