27
INSTALLATION MANUAL PRORAPID |
Factory Settings
All settings can be reset, returning the
controller to its delivery state.
!
All of the controller‘s
parametrization, statistics,
etc. will be lost irrevocably.
The controller must then be
commissioned once
again.
Time & Date
Serve to set the current time and date.
!
For time-dependent
functions such as circulation
and anti-legionella and the
evaluation of system data,
it is essential that the time
is accurately set on the
controller. Please note that
the clock continues to run
for about 24 hours if the
mains voltage is interrupted,
and afterward must be reset.
Improper operation or an
incorrect time may result in
data being cleared, recorded
incorrectly or overwritten.
The manufacturer accepts
no liability for the recorded
data!
Daylight saving time
If this function is activated, the controller
automatically changes to winter time or
summer time (DST, Daylight Savings Time).
Eco Display Mode
In Eco Display Mode the backlight of the
display is switched o if no buttons are
pushed for 2 minutes.
!
If a message exists, the
backlight does not switch
o until the message has
been scanned by the user.
Temperature unit
In this menu you can select between the
temperature units °C and °F. 19
To Next Page
Loading...