CHWS PRORAPID - Installation Instructions

5
INSTALLATION MANUAL PRORAPID |
Installation Instructions
General Information
This instruction manual is an integral and
essential part of the product check that it is
always furnished with the CHWS ProRapid
DHW generator.
Carefully read the instructions contained
in this chapter as it provides important
information for the correct and safe
installation and use of the appliance.
After the installation please deliver this
manual to the user. The installation and
start-up operations must be performed by
professionally qualied technicians having
the specic skills required in the heating
system sector.
The manufacturer declines responsibility for
any damage to persons or property caused
by a faulty installation or start up.
Important: This appliance should be used
only for the purpose mentioned any otheruse
is improper and therefore dangerous. Before
performing any operation on the appliance,
turn o the electric power supply and close
the water supply tap.
The use of any electric component involves
the observance of the following fundamental
rules:
• Always turn o the electric power
supply switch before touching any
electrical connection
• Do not touch the appliance with parts
of the body which are wet, damp or in
bare feet
• Do not pull the electric wires
• Do not expose the appliance to
atmospheric conditions
• Do not leave the appliance on when
not in use always turn the water and
electric supplies o.
Start Up
Before starting up the CHWS ProRapid
DHW generator, check that the unit is not
damaged if in doubt, do not use it and
contact CHWS Ltd.
The transport and positioning of the
appliance should be carefully performed
with the proper lifting hook. Avoid banging
or forcing the control board and the
insulation. The installation should be
performed in a suitable environment.
The CHWS ProRapid is suitable for
operating at 6 bar working pressure both for
sanitary and heating purposes. In the event
that the hydraulic pressure is higher than 6
bar, insert a pressure reducer in the
sanitary water supply.
Always cover both the sanitary hot
water and the heating water pipes with
an insulating coating according to the
regulations in force.