CILICO CT10X - Inventory Mode

To Next Page

To Previous Page

1.2.1 Inventory Mode

If you want to keep the barcodes in the buffer of CT10X for multiple

uploading, you can choose inventory mode. In inventory mode,

CT10X will count the number of the barcodes automati- cally, and

control the time, position etc. for uploading. Also, you can clear the

barcodes in the buffer after uploading. Following is the setup

method:

1. Read ‘Enter Inventory Mode’ barcode to enter into the inventory

mode

Enter Inventory Mode

2. If you want to recover to normal mode, read the ‘Enter Normal

Mode’ barcode

Enter Normal Mode

3. Read the ‘Clear the barcodes in the buffer’ barcode to clear the

barcodes (only suitable for inventory mode)

Clear the barcodes in the buffer

4. Read ‘Data Uploading’ barcode to upload the barcodes in the

buffer (only suitable for inventory mode)

Data Uploading

5. Read ‘Upload Counting’ barcode to count the number of the

barcodes (only suitable for inventory mode)

Upload Counting

Note: Inventory function can be used under any scan mode

mentioned in 1.5.