CILICO CT10X - Select Output Interface

To Next Page

To Previous Page

2.1. Select Output Interface

Either SPP or HID can be chosen depending on the need.

2.1.1 BT SPP Mode

If you select the output interface of BT SPP, you may run

HyperTerminal.exe or serial port tool to collect the scanned data.

Enable SPP

You can setup SPP data batch upload or single upload according to

your requirements.

SPP Data Batch Upload

SPP Data Single Upload

2.1.2 BT HID Mode

By default, BT HID is activated on the CT10X Scanner, and the

keyboard type is set to PCAT (US).

(*)Enable HID Enter Setup

Exit with Save

Exit without Save