CE318-T Photometer
User Operation Manual
Revision V4.10 October 2021
21
15. Assemble the collimator to the sensor head front plates by tightening
strongly the long central threaded rod using a plier. The notch must face
the 4 quadrants lens on the sensor head front plate.
Note: Watch out that the collimator and the sensor head are completely
interdependent. There should be no slack while trying to move the collimator after
having tightened it.
16. Strap the sensor head on the V-shaped support of the robot. Two things
are to be checked. First align the sensor head front plate with the upper
surface of the V-shaped support. Then use the notches present both on
the robot and the sensor head as a visual indicator to position the sensor
head correctly. Notches have to be aligned.
To Next Page
Loading...
Need help?
General